strip brushes
Specification
Steel Channel Strip
Filament is held under the holding wire,
which-in turn is held in place by the closure of the strip back.
SPECIFYING STRIP
Strip is speci?ed by the width of the “Strip Back”,the ?lament,
the overall height and the length of the strip.
(eg. 8mm strip, Crimped Nylon, 24mm O/H x 1000mm Long)
The height of the strip back approximately the same as the Strip Back size.
STRIP BACK WIDTHS:
The continuous Brush Strip sizes available, are as follows:
3mm – 3.5mm – 4mm – 4.8mm – 5mm – 6mm – 8mm – 10mm – 12mm – 14mm
STRIP BACK MATERIALS:
Strip Backs can be produced in Galvanised or #304 Stainless Steel
STRIP FILAMENT:
Polypropylene filament is stocked in Crimped and Level material from 0.008″ to 0.100″
Nylon filament is stocked in Crimped and Level material from 0.005″ to 0.050″
(generally 66 Nylon though some stock of 612 are also held)
Wire, Stainless Steel, Galvanized & Brass are also available.
For other filament materials held in stock and for a brief description of
material characteristics/specifications please refer to the materials page of our website.
STRIP HOLDERS:
Aluminium Preformed (extruded) aluminium holder are available, ex-stock for 4mm & 8mm strips
DOUBLE BACK STRIP:
Double back strip is available for all strip back sizes.
“Double Back” Channels are commonly used as holders for brush strip (with or without welded ?anges attached)
and can be supplied ?tted to or separate from the brush strip.
WOOD MOUNTING:
Continuous brush strip can be mounted into most wooden forms by epoxy fixing into dovetail routed channels.
Thus retaining the advantage of the even continuous face of brush strip with the versatility of wooden back fixing.
| CODE | DESCRIPTION |
|---|---|
| T10395 | 14mm Galv. still strip brush 450mm o/h x 1500mm L 0.090" level poly fil - Fitted into (crimped,dimpled into position) galv. steel welded “h” channel holder with 24mm leg. |
spiral strip brushes
STRIP BRUSHES:
Strip brushes can be wound according to application.
For light work it may be more suitable
to “open-up” the strip to achieve a
less dense and hence more flexible brush.
For heavy work or where greater pressure will be required
it is more advantageous to closely wind.
SPIRAL STRIP BRUSHES
Spiral Strip brushes can be supplied either
onto a refillable core, onto a shaft or can be supplied
loose for fitting to customer’s existing shaft
ROLLER BRUSHES
Punched Roller Brush are made by stapling knots of ?ll material
into a pre drilled Polyethylene core.
Core sizes can vary from 40mm to 120mm in diameter.
A variety of ?ll patterns and density can be obtained depending on the application.
The more common patterns use staggered rows or herringbone.
They can be filled with a variety of material:
Polypropylene, Polyester, Horse Hair, Coco Fibre, Brass wire,
Galvanized or Stainless Steel wire.